![]() Platform Cable USB II attaches to the USB port on a desktop or laptop PC using an off-the-shelf Hi-Speed USB A-B cable. ![]() Platform Cable USB II is backwards compatible with Platform Cable USB and is supported by all Xilinx design tools that support Platform Cable USB. The status LED on Platform Cable USB will be GREEN if target voltage is in the proper range and applied to the correct pin.Ĭonnecting to cable (Parallel Port - LPT1).Ĭonnecting to cable (Parallel Port - LPT2).Ĭonnecting to cable (Parallel Port - LPT3).Ĭonnecting to cable (Parallel Port - LPT4). Platform Cable USB II is intended for prototyping environments only. Check that power is applied to the target system and that the ribbon cable is properly seated at both ends. Sinkr JTAG Download Debugger DLC9 DLC9LP Compatible for XILINX Platform Cable USB FPGA CPLD in-Circuit Debugger Programmer 1 1 offer from 42. ![]() Max current requested during enumeration is 280 mA.ĮRROR:Cse - A reference voltage has not been detected on the ribbon cable interface to the target system ( pin 2 ). If your board has an onboard Digilent USB-JTAG module, use a USB cable. Click Silicon Labs CP2103 USB to UART Bridge Controller 0100 4. *** WARNING ***: When port is set to auto detect mode, cable speed is set to default 6 MHz regardless of explicit arguments supplied for setting the baud ratesĭriver windrvr6.sys version = 10.2.1.0. (A) Click Devices, (B) click USB and (C) click USB Settings. WARNING:UtilitiesC - Message file "usenglish/Cse.msg" wasn't found.
0 Comments
Leave a Reply. |